Brightpeak Connect

GuidesInspection & testing · Guide 03

5 min read

2391-50 vs 2391-51 vs 2391-52: which inspection and testing course do you need?

What City & Guilds 2391-50, 2391-51 and 2391-52 each cover, who they suit and which one to book.

Brightpeak ConnectChecked against the City & Guilds qualification handbooks (April 2026)Published 9 November 2026Checked 9 November 2026
Contents
  1. The short answer
  2. 2391-50, 2391-51 and 2391-52 side by side
  3. Which one is right for you?
  4. Where does 2392-10 fit?
  5. Can anyone book 2391-52?
An electrician in a hard hat and face shield working on a distribution board
Photo: colsan ltda, Unsplash.

The short answer

2391-50 covers testing new work, 2391-51 covers inspecting existing installations, and 2391-52 covers both. If you want to sign off your own jobs and carry out EICRs, 2391-52 is the one most people are asked for.

2391-50, 2391-51 and 2391-52 side by side

All three are Level 3 City & Guilds awards. The difference is what kind of inspection and testing they cover.

City & Guilds 2391-50, 2391-51 and 2391-52 compared
2391-502391-512391-52
Full nameLevel 3 Award in Initial Verification of Electrical InstallationsLevel 3 Award in Periodic Inspection and Testing of Electrical InstallationsLevel 3 Award in Initial and Periodic Inspection and Testing of Electrical Installations
What it’s forTesting new work before it’s switched onInspecting installations that are already in useBoth
The paperwork you’ll know it forElectrical Installation Certificates (EICs)EICRs (Electrical Installation Condition Reports)EICs and EICRs
Who it suitsInstallers who want to test and certify their own new circuitsElectricians moving into landlord, maintenance or condition report workElectricians who want to do the lot

How 2391-52 is assessed (from the City & Guilds handbook, April 2026):

  • An online exam: 60 multiple choice questions in 120 minutes. It’s open book, so you can use your regs. The pass mark is around 75%.
  • A practical assignment: a hands on task where you inspect and test an installation.

The qualification has 50 guided learning hours and 67 hours total qualification time, so expect some evening reading on top of the course days.

2391-50 and 2391-51 are assessed the same way, but shorter: 40 questions in 90 minutes, plus a practical assignment.

Which one is right for you?

Which 2391 course to book
If you…BookWhy
Install new circuits and want to sign off your own work2391-50You only need initial verification
Want to carry out EICRs for landlords, letting agents or businesses2391-51Periodic inspection is the whole job
Want both, or aren’t sure yet2391-52One course covers both
Have never done inspection and testing beforeStart with 2392-10See the next section

If you only do EICRs, the 2391-51 course is enough. If you need both, 2391-52 does it in one course, with one set of assessments instead of two.

Where does 2392-10 fit?

2392-10 is the Level 2 starter course, for people who are new to inspection and testing. Its full name is the Level 2 Certificate in Fundamental Inspection, Testing and Initial Verification.

It covers the basics of initial verification and is often described as a first step towards 2391. If you already test your own work regularly, you can usually skip it and go straight to 2391-52.

Can anyone book 2391-52?

No. It’s for working electricians. The City & Guilds handbook says:

  • You should already hold a Level 3 electrotechnical qualification or similar.
  • It is not suitable for people new to the industry or with limited electrical experience.
  • You must be 18 or over.
  • Your training centre should do an initial assessment before you enrol.

The initial assessment is there so you don’t pay for a course you’re not ready for.

It’s endorsed by the IET. It can lead on to the Level 4 Award in the Design and Verification of Electrical Installations (2396).

Quick questions

What’s the difference between 2391-51 and 2391-52?

2391-51 covers periodic inspection only (EICRs). 2391-52 covers periodic inspection and initial verification of new work.

Is the 2391-52 exam open book?

Yes. It’s a 60 question online multiple choice exam lasting 120 minutes, and you can take your reference books in. The pass mark is around 75%.

Do I need 2392-10 before 2391?

Not always. If you’re new to inspection and testing, 2392-10 is the usual starting point. If you already test your own work, you can usually go straight to 2391-52.

Can a newly qualified apprentice do 2391-52?

City & Guilds says it’s for electricians who already hold a Level 3 qualification, and not for people with limited experience. Your training centre will check you’re ready with an initial assessment.

Is 2391 the same as “inspection and testing”?

Yes. When electricians say “I’ve done my inspection and testing”, they usually mean a 2391 qualification.

Our 2391-52 course

You study the theory online, in the evenings, around your jobs. Then join us in Derby for the classroom and practical, and sit both City & Guilds assessments there.

You get the same City & Guilds certificate as at any other centre.

See the 2391-52 course →

Sources

Keep reading